UNIVERSAL FURNACE FAN CONTROL

Call us to Create your Wholesale Account

Dinosaur Electroinics Inc. Ignitor Boards

6 in stock (can be backordered)

Description

FAN 50 Plus

Replacement Ignitor Board w/Fan Control for Hydroflame & Suburban Furnaces

When this board senses a “failure to ignite” or “loss of flame” condition it will wait one minute and shut the fan motor off instead of blowing cold air and maybe running the battery down. It replaces Dinosaur Electronics previous large and small Fan boards as well as the newer OEM Fan boards used in some Atwood®/Hydro-Flame® furnaces. The board is fuses, and a diagnostic LED on the board glows “GREEN” when power is applied to the board and turns “RED” when the board Activates the gas valve.

THE FAN FEATURE MUST BE USED WHEN INSTALLING THE FAN 50 PLUS.

DO NOT USE IN DUO-THERM 900 SERIES FURNACES WHERE THE THERMOSTAT IS IN THE GROUND CIRCUIT.

  • Replaces the 59-uibfancontrolsm board
  • For replacement of Hydroflame, Suburban, and now Atwood furnaces fan control boards and can also be used to implement the fan control feature in most 12 VDC DSI furnaces.
  • Replaces Hydroflame part #37875 and Suburban part #232613
  • Tech Tip: (this unit can be configured for use as a standard fan control board by removing a jumper on board) 12volt only 20sec fan on delay before ignition, 3 try igniton board all Dinosaur boards are UL and TEI listed.

Warranty Terms: 3 Year Factory Warranty

Additional information

Weight 2 lbs
Dimensions 4.5 × 3.25 in
Manufacturer

special-order-only

Special Order Only